a lot of wires…

loading connector with led

light up when pressing

or all four leds permanent on

gunlord wireless with neogeo stick

Some cutting and dremel at the UWRC Receiver (forgive me micro)

more cutting and rewiring

ready to go

I used my IFU-30 Unit, so there was no need to remove the RF Unit. As I didn’t wanted some wires to the left or right side.

I put all needed connections to the rear side. Power, RGB-Out, Audio Out.

I opened the RF-box removed the orignal switch and replaced it with UWRC switch.

ground to one side and the other side of the switch to the uwrc board

thanks again to micro, for his great Idea how to make the UWRC plugable, by removing the filters.

green wire uwrc controll switch, red and black to the signal led combo I created at the upper side

blue „bigger“ wires to the 7805 replacement for swiching the pce off/on

a red 5mm led and a green 5mm led dremel work and to the ventilation grid

no more heat -> replacement of the 7805

Great feature, you can power off and on the PC-Engine via holding select and Run for around 1sec. Ideal for users of everdrives. Hope this feature will find his place in all new internal receivers from micro

Final Pic

Branded to capcom, nice, never seen something like this before

But its time to desolder the original Capcom heart. So we didn’t get any interfear

position of uwrc tx board

wiring

changing of charging resistor to 5,11k -> around 200mA current for the big one 3000mAH Lipo, hope not to recharge it in a lifetime

preparing of usb port/led

some pictures

capcom rules

removing the original controller

some dremel work

wiring of uwrc

I used a 200mAh Lipo and changed the loading current to 50mA via changing loading R from 10k to 20k

loading led, usb port, lipo

done

I was modified before with A2600RGB from tim worthington and I used some more switches like select, reset from the Atari and extra button from tim worthingstons 2600RGB PCB

UWRC

Button A = normal FireButton 1 of Atari (Pin 6)

Button B = Firebutton 2 (Pin 9)

Select  =    Extra Button A2600RGB PCB

Start  = Start of Atari 2600

Button C= Select of Atari 2600

Button D = Palette switch A2600RGB PCB

All normal Controllers will work after mod too. Like paddle, racing, joystick.

(diodes, needed to make special functions from A2600RGB working, R=10k as pullup)

RX Led to show it though the power switch hole upperside red led down side gn led

thanks to the PCB of micro and some reposition of the led usb powersupply it works great.

I put it at the hole of the original wire and with some hotglue it works

a little comparsion between yesterdays remote and state of the art :-)))

Marked R used for different current while loading LiPo

I=1000V/R

for

400mAh Lipo (Standard) ->100mA  R=10k

250mAh Lipo  ->050mA  R=20k

3000mAh Lipo ->200mA  R=5k

Voltage Regulator used: 2,3V Maximum Voltage: 5,5V